Operation And Display Section For Remote Control; Current Time Setting - Mitsubishi SKM15ZSP-W User Manual

Operation and display section for remote control

FAN SPEED button
Each time the button is pressed, the fan
speed changes.
Page 11
HI POWER/ECONO button
This button changes the HIGH POWER/
ECONOMY mode.
Page 17
ON TIMER button
This button selects ON TIMER operation.
Page 15
SLEEP button
This button selects SLEEP operation.
Page 14
CLEAN switch
This switch selects the SELF CLEAN
mode.
Page 18
CANCEL button
This button cancels the ON timer, OFF
timer, and SLEEP operation.
Display in OFF status
The current time and present
OPERATING MODE are displayed
while the air-conditioner is turned off.

Current time setting

■ When inserting the batteries, the current time is automatically set to time setting mode.
13:00 is displayed as the current time. Set the clock to the right time.
The above illustration shows all controls, but in
practice only the relevant parts are shown.
Transmission procedure
When each button on the remote control is
pressed – with the remote control pointing
towards the air-conditioner unit, a signal is
transmitted.
When the air-conditioner receives the signal
correctly, it will beep.
Example: Set to 10:30.
1
Press the ACL switch.
Press with the tip of a ballpoint pen, etc.
The time display blinks and can be set to the current time.
2
Press the
(Set to 10:30)
3
Press the ON/OFF button.
The display changes from blinking to steady lighting and the setting is complete.
Make sure to press the button within 60 seconds from the last operation in
step 2, otherwise the time is not set.
NOTE
The timer operation works based on the time clock, so please set it correctly.
The remote control data is reset when the present time is set.
EN-10
OPERATION MODE select button
Each time the button is pressed, the
mode changes.
ON/OFF (luminous) button
Press to start operation, press again to
stop.
AIR FLOW (UP/DOWN) button
This button changes the airflow (up/
down) direction.
TEMPERATURE button
These buttons set the room temperature.
(These buttons are used for setting the
current time and timer function as well.)
OFF TIMER button
This button selects OFF TIMER
operation.
ACL switch
This switch resets the program to default
state.
or button.
Page 11,12
Page 13
Page 14
Page 9