Chengdu Ebyte Electronic Technology Co., Ltd.
2.4 Quick to use
Switch the radio to configuration mode, as shown below:
Turn on the host computer, confirm the correct baud rate parameter "1", click "Open serial port", confirm
whether the host computer configuration mode is checked, the device is in configuration mode, this parameter
should be checked, as shown in the following figure:
The purpose of the "Quick Start" here is to use the device quickly, and the parameters use the factory
parameters. If the device has been configured before, click "Factory Settings" to restore the factory parameters:
Copyright ©2012–2021, Chengdu Ebyte Electronic Technology Co., Ltd.
E90-DTU(400SL30L)_UserManual_EN
5