Table of Contents
Advertisement
Items
(1) POWER LED
(2) ALARM LED
(3) Programm LED
(4) RUN LED
(5) Monitor LED [Hz]
(6) Monitor LED [A]
(7) RUN command LED
(8) 7-seg LED
(9) RUN key
(10) STOP/RESET key
(11) CYCLE key
(12) Up key
(13) Down key
(14) SET key
(15) USB connector
(16) RJ45 connector
04 Commissioning
Contents
Turns ON (Green) while the inverter is powered up.
Turns ON (Red) when the inverter trips.
· Turns ON (Green) when the display shows
changeable parameter.
· Blinks when there is a mismatch in setting.
Turns ON (Green) when the inverter is driving the
motor.
Turns ON (Green) when the displayed data is current
related.
Turns ON (Green) when the displayed data is current
related.
Turns ON (Green) when a Run command is set to
the operator. (Run key is effective.)
Shows each parameter, monitors etc.
Makes inverter run.
· Makes inverter decelerates to a stop.
· Reset the inverter when it is in trip situation.
· Go to the top of next function group, when a
function mode is shown.
· Cancel the setting and return to the function code,
when a data is shown.
· Moves the cursor to a digit left, when it is in digit-
to-digit setting mode.
· Pressing for 1 second leads to display data of
d001, regardless of current display.
· Increase or decrease the data.
· Pressing the both keys at the same time gives you
the digit-to-digit edit.
Go to the data display mode when a function code is
shown.
· Stores the data and go back to show the function
code, when data is shown.
· Moves the cursor to a digit right, when it is in digit-
to-digit display mode.
Connect USB connector (mini-B) for using PC
communication.
Connect RJ45 jack for remote operator.
14
Advertisement
Table of Contents
