Table of Contents
Advertisement
● Do not install this product near a heat source or in direct sunlight.
● This appliance must be earthed.
● The appliance must be connected to a 100‐240 volts 50‐60 hz AC supply by means of a
three pin socket, suitably earthed and the outlet should be protected by a 10 amp fuse.
● Use of controls, adjustments or performance of procedures other than those specified in
the user manual may result in damage of the device or injury.
● To avoid the risk of accidents and damage to the machine, please read these instructions
carefully before using it for the first time. They contain important information on its safety,
use and maintenance. Keep these instructions in a safe place and ensure that new users
are familiar with the content. Pass them on to any future user.
● The mains cord may only be replaced with one with similar or better rating(250V/10A)
13 Cleaning instructions
Do NOT use
● Alcohol/solvents at higher concentration > 5%
● Strong alkalis lye, strong solvents
● Acid
● Detergents with fluoride
● Detergents with ammonia
● Detergents with abrasives
● Steel wool
● Sponge with abrasives
● Steel blades
● Cloth with steel thread
13.1 Camera
● Gently blow on the lens to free any stray particles.
● If you still notice particles on the edges of the lens, very gently dislodge them with a small,
soft brush.
● Gently rub the lens with the microfiber cloth, moving in a circular motion. Start in the
middle of the lens and work your way to the edges.
● If the microfiber cloth doesn't remove all of the grime or smudges, use a few drops of lens
cleaning fluid or clean water. Place the drops onto the cloth, not onto the lens. Then repeat
the circular motion of the cloth. First use the damp area of the cloth, and then repeat the
motion with a dry area of the cloth.
User Manual
mSorter OCR
Updated 2019‐03‐15
Page 34/38
Advertisement
Table of Contents
