Seagull Models CESSNA TURBOSKYLANE182 Assembly Manual page 4

CESSNA TURBO SKYLANE 182 ELECTRIC 69" WINGSPAN PNP
Check that the servo arms for the eleva-
tor (1) and rudder (2) are at 90-degrees to the
pushrods. Adjust the sub-trim of the radio or
reposition the servo arms as necessary.
3.
INSTALLING THE HORIZONTAL
STABILIZER
1.
Check all alignments. Mark the outline of
the fuselage on the top and bottom of the sta-
bilizer.
2.
4
3.
2
1
4.
5.
Instruction Manual.
Use a ruler and carefully cut the covering
1/8 inch (3mm) inside the line drawn on the
stabilizer to remove the covering from the
center of the stabilizer. Remove the top and
bottom covering. Use care not to cut into the
underlying wood, weakening the stabilizer.
Lightly sand the elevator joiner wire where
it contacts the elevators. Use a paper towel
and isopropyl alcohol to remove any oil or
debris from the joiner.
Fit the joiner wire into the elevator halves.