Seagull Models CESSNA TURBOSKYLANE182 Assembly Manual page 10

CESSNA TURBO SKYLANE 182 ELECTRIC 69" WINGSPAN PNP
11.
ELEVATOR AND RUDDER
LINKAGE CONNECTIONS
Remove the 2mm nut from the elevator
ball link. hread then screw Use a 1.5mm
hex wrench to thread the screw through
the center hold of the elevator control
horn.
1.
With the radio on and the elevator stick
and trim centered, use a ruler to check
that the elevator is aligned with the sta-
bilizer.
2.
10
If the elevator and stabilizer are not
aligned, thread the ball on the elevator
in or out to correct the alignment. Make
sure to thread the ball end at the control
horn and servo arm equally as not to
damage the ball ends.
3.
Once the elevator and stabilizer are
aligned, use a 1.5mm hexn wrench to
tighten the screw while holding the 2mm
locknut with hemostats or needle nose
pliers.
4.
Repeat the steps for the elevator to at-
tach the rudder pushrod and ball end to
the rudder control horn.
Instruction Manual.