Speci Ications; Fcc Statement - Hover-1 PRO Series Owner's Manual

SPECIFICATIONS SPECIFICATIONS
Model: H1 BSS
Net Weight: 46.95 lb (21.3kg)
Max Supported Weight: 264 lbs (120kg)
Min Supported Weight: 77 lbs (35kg)
Max Speed:
Up to 20 mph (32 km/h)
Max Range: Up to 24 miles (40 km)
Battery Type: Lithium-ion
Rated Power: 500W
Max Power: 800W
Battery Voltage: 36V
Battery Capacity: 10Ah
Power Requirement:
100V-240V, 50 Hz/60 Hz
Folded Size: 46.6 in. x 8.2 in. x 20.4 in.
(118.4 cm x 21 cm x 52 cm)
Open Size: 46.6 in. x 20 in. x 45.9 in.
(118.4 cm x 51 cm x 116.6 cm)
Tire Type:
Inner Honeycomb Solid Tire
Tire Size: 10" Front & Rear
Brake Type: Front Drum/Rear Disc
FCC ID: 2AANZBSS
37
07

FCC STATEMENT

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
38