Ending The Programming Sessions - MTS Systems Level Plus Operation And Installation Manual

18 Ending The Programming Session
This completes the cycle of parameter entries for the Level Plus monitor. If you are using more
than one tank, be sure to repeat all necessary parameter assignments for each additional tank.
If you wish to enter more parameters press the MODE key. If you have finished entering parame-
ters press the ENTER key. The system will then initialize and begin displaying measurements.
If the MODE key is pressed, the user can select the type of parameters to edit.
NOTE
The initialization sequence takes approximately 5 to
10 seconds per tank gauge.
' E n t e r ' T O R E S U M E
M E A S U R E M E N T S
O R ' M o d e ' T O C H A N G E
O T H E R P A R A M E T E R S
S E L E C T E D I T F U N C T I O N
1 = S Y S T E M P A R A M E T E R S
2 = T A N K P A R A M E T E R S
3 = T E S T F U N C T I O N S
75