System Parameters - MTS Systems Level Plus Operation And Installation Manual

12

System Parameters

Display Viewing Angle
Press the MODE key to change the LCD display viewing angle (contrast).
Use the number keys to enter a new display contrast value (1-8) and press the enter key.
Security Access Codes
You are given the opportunity to change your access codes. Security access codes are
used to limit access to program mode and Level Plus mass stabilization mode. There are
three different codes available. Security code #1 is used to limit access to program mode.
Security code #2 is used to enable mass stabilization mode and code #3 is used to disable
mass stabilization mode. Each code must be unique for the security access system to
work properly. If you wish to change any of your codes press the MODE key; otherwise,
press the ENTER key and proceed to LEVEL DISPLAY UNITS.
Type in your new security code (up to 6 characters) and press the ENTER key. If you
wish to eliminate the code just press the ENTER key. This will allow anyone to access the
monitor by pressing the ENTER key.
34
D I S P L A Y C O N T R A S T = 5
' M o d e ' T O C H A N G E
' E n t e r ' T O C O N T I N U E
D I S P L A Y C O N T R A S T = -
' 1 ' = M I N I M U M ( L I G H T )
' 8 ' = M A X I M U M ( D A R K )
' E n t e r ' N E W V A L U E
NOTE
The LCD is a top view type. The best viewing angle
will be observed when the display is positioned at or
below eye level.
S E C U R I T Y C O D E # 1
' M o d e ' T O C H A N G E
' E n t e r ' T O C O N T I N U E
S E C U R I T Y C O D E # 1
- - - - - -
' E n t e r ' N E W V A L U E
( u p t o 6 c h a r a c t e r s )