Analog Parameters - MTS Systems Level Plus Operation And Installation Manual

15

Analog Parameters

Use the number keys to select the analog output number to edit and press the ENTER key. The
eight available analog output channels are referenced as analog output #1 to analog output #8.
The analog output #1 assignment is shown. To change this assignment press the MODE key.
Enter the tank number that analog output #1 will be assigned to, or enter "0" to disable the ana-
log output.
The default output value for analog output #1 is shown. This control parameter defines the state
of the analog output channel when system errors occur. System errors include uninitialized data
(after power-up), invalid volume data and tank gauge errors. Press the MODE key to change the
default output value. The available choices are 4 ma, 20 ma and LAST VAL.
The analog output #1 is assigned to TANK #1, PRODUCT. Press the MODE key to change the
analog control parameter. Available parameters are:
52
S E L E C T A N A L O G O U T P U T
T O E D I T :
' E n t e r ' T O C O N T I N U E
A N A L O G O U T P U T # 1
A S S I G N E D T O T A N K # 1
' M o d e ' T O C H A N G E
' E n t e r ' T O C O N T I N U E
A S S I G N O U T P U T # 1
T O T A N K # - -
E N T E R T A N K N U M B E R O R
' 0 ' T O D I S A B L E O U T P U T
A N A L O G O U T P U T # 1
O N S Y S E R R = 4 m a
' M o d e ' T O C H A N G E
' E n t e r ' T O C O N T I N U E
• Interface level • GOVP
• Product level • GOVI
• Temperature • GOVT
( 1 - 8 )
• NSVP
• MASS
• GOVU