Connections - Panasonic AW-RP60G Operating Manual

Connections

Set the connection setting to "Serial" or "LAN" in the [CONNECT SETTING] menu.
CAM SEL
CAM1
CAM5
When connecting, observe the following points.
Serial connection
Connect the <SERIAL CONT 1 to 5> connector on this unit to the <RS-422> connector on the AW-UE150 using a LAN
cable (sold separately).
Use a straight cable (category 5e or higher; up to 1000 m (3280 ft) in length) for the LAN cable.
Do not connect a cable for PoE supply to the <SERIAL CONT 1 to 5> connector of this unit.
LAN connection
Connect the <IP CONT> connector on this unit to the <LAN LINK/ACT> connector on the AW-UE150 using a LAN cable
(sold separately).
Use a straight cable or cross cable (category 5e or higher; up to 100 m (328.0 ft) in length) for the LAN cable (STP).
Configure the camera IP address and port number settings of the connection destinations in [SYSTEM] menu as well.
This unit can be powered using PoE. Use a switching hub with PoE support.
For details on switching hubs and PoE injectors that have been verified to support PoE, consult with your dealer.
CONNECT
MODE
CAM2 CAM3
CAM6 CAM7
- 4 -
Connecting the Unit to AW-UE150 Series Cameras
CAM4
CAM8