Changing Parameters At The Operator Level (A); Parameter List At The Operator Level (A) - Dürkopp Adler Class 271 Instruction Manual

8.2.4 Changing Parameters at the Operator Level (A)

The parameter values at the operator level (see Parameter List 8.2.5) can be changed
as follows.
–
Turn the mains switch on, do not operate the pedal.
–
The "Manual Sewing" work mode is active (the LED in the key 5 (P/M)) is dark).
–
Press the 6 (T/E) key, the LED is lit, sewing is no longer possible.
–
The first parameter at the operator level is shown in the display.
Example:
NumberMeaning
1 Number of forward stitches in the beginning bartack
3 Number of reverse stitches in the beginning bartack
5 Number of reverse stitches in the end bartack
7 Number of forward stitches in the end bartack
10 Parameter number (hundreds)
11 Parameter number (tens)
12 Parameter number (ones)
14-16 Parameter value
–
The parameter value can be changed with the L+ or L- key
–
The parameter number can be changed with the P+ or P- key (hundreds) or with
the S+ or S- key (tens and ones).
–
Press the 6 (T/E) key, the setting is saved, the operator level A is exited, the LED is
dark and sewing is possible again.

8.2.5 Parameter List at the Operator Level (A)

Parameter
No. Abbr. Designation/Function
111 LS Light barrier compensation stitches
112 LS Number of stitches to the light barrier mark
by knitted goods
116 SANL Number of softstart stitches
148 AR Beginning bartack-double = I, single = II
149 ER End bartack-double = I, single = II
450 LS/STL Light barrier compensation stitches by short
sewing length
523 RIE/ Change-over fancy-stitch bartack = I,
ZRIE normal bartack = II
64
Change via:
P+ or P- key
S+ or S- key
S+ or S- key
L+ or L- key
Setting RangePreset
min max 100R
1 255 6
0 255 0
0 255 2
I II I
I II I
1 255 6
I II II