Electronic Function; Indication Lamp - Makita XHU09 Instruction Manual

To start the tool, hold the front handle while pressing the
switch lever and pull the switch trigger. To stop the tool,
release either the switch trigger or the switch lever.
1
Fig.3
► 1 . Front handle 2. Switch lever 3. Switch trigger

Indication lamp

Fig.4
► 1 . Indication lamp
The indication lamp blinks or lights up when the battery
becomes low or the tool is overloaded. Refer to the
following table for the status and action to be taken.
Indication lamp Status
The lamp blinks The remaining
in red. battery is low.
The lamp lights up The remaining
in red. battery is empty.
The tool has
stopped due to
overload.
The tool has
stopped due to
overheat.
NOTE: The time at which the indication lamp blinks or
lights up varies by the temperature around the work
area and the battery cartridge conditions.
2
3
1
Action to be taken
Recharge the
battery, or replace
the battery with a
charged one.
Recharge the
battery, or replace
the battery with a
charged one.
Turn off the tool,
and remove the
cause of overload.
Turn off the tool,
and cool down the
tool and battery.

Electronic function

The tool is equipped with the electronic functions for
easy operation.
• Constant speed control
The speed control function provides the constant
rotation speed regardless of load conditions.
• Electric brake
This tool is equipped with an electric brake. If the
tool consistently fails to quickly stop the shear
blades after releasing the switch trigger, have the
tool serviced at Makita Authorized Service Center.
• Accidental re-start preventive function
Even if you install the battery cartridge while pull-
ing the switch trigger, the tool does not start. To
start the tool, first release the switch trigger, and
then pull the switch trigger.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When replacing the shear blades,
always wear gloves so that your hands do not
directly contact the blades.
NOTICE:
When replacing the shear blades, do
not wipe off grease from the gear and crank.
Installing or removing the shear
blades
CAUTION:
Attach the blade cover before
removing or installing the shear blades.
1. Attach the blade cover to the shear blades.
Fig.5
► 1 . Blade cover
8 ENGLISH
1