Table of Contents
Advertisement
Table of Contents
Specifications
Height-of-Cut: The cutting height is adjusted on
rear roller by two vertical screws and held by two
locking capscrews. Bench height-of-cut range is
2.4mm to 26mm. Cutting units will deliver differing
effective heights of cut, depending on their configura-
tion.In fact, effective cutting height may be influ-
enced by the following factors; turf conditions, roller
profiles, cutting unit attitude, cutting unit accessories,
weight of the cutting units and bedknife profile.
Therefore, bench setting a cutting unit does not equal
the effective (actual) height of cut you achieve. You
must determine how to adjust your cutter on the
bench to achieve a comparable height of cut to a cut-
ting unit of a different configuration, model, or brand.
Reel Construction: Reels are 13cm in diameter,
53.3 cm in length. High-carbon steel blades are weld-
ed to 5 stamped-steel spiders. and heat treated to RC
48-54 hardness. The reel is ground for diameter, con-
centricity. and back grind.
Reel Bearings: Two double-row ball bearings, 30
mm I.D., press fit onto the reel shaft. The inverted
seal is pressed onto the reel shaft. Bearing side load is
maintained by a 3-
1
⁄
turn wave washer, with no
2
adjusting nut.
Reel Drive: The reel shaft is a 1.375 inch (3.493
cm) diameter tube with drive inserts permanently
pressed in both ends. A replaceable floating coupler
with an internal eight-tooth spline is factory installed
on the right end, and held in place by a snap ring. The
floating coupler may be moved to the other end when
the cutting unit is used on the tractor's front right
position.
Frame Construction: A single top tube is welded
to two side plates. A bolt-in cross rod acts to set the
front frame width and stiffen the assembly. The lift
Page
2
3
4
4
5
5
straps have a replaceable roller that may be moved to
change transport height.
Bedknife: Replaceable, 13-screw, single-edged, high
carbon steel bedknife austempered to RC 48-55,
fastened to a machined cast iron bedbar. Tournament
bedknife is standard.
Bedknife Adjustment: A single control screw has
detents corresponding to .018 mm bedknife move-
ment for each indexed position. A linear adjustment
on the bedbar left end allows leveling of the bedknife
to the reel blades. A centered lever arm regulates the
knife-to-reel contact with two rubber bushings acting
as pivots.
Front Roller: The standard front roller is a 6.4 cm,
diameter full-radious Weihle. The right bracket has an
eccentric shoulder bolt to provide leveling. A second
eccentric may be added to the left bracket for
increased leveling range. The roller has a through
shaft with greaseable ball bearings.
Rear Roller: The standard rear roller is a 5.2 cm
diameter smooth roller. It has a through shaft with
greaseable ball bearings.
Front Shield: A snap-in shield covers the lower
front of the reel. The shield helps improve grass
throwing into the basket and prevents the basket seal-
ing flap from being damaged by the reel.
Options:
Micro-Cut Bedknife
Lo-Cut Bedknife
High-Cut Bedknife
Fairway Bedknife
5-blade heavy duty reel
8-blade heavy duty reel
2
5
6
6
7
7
7
Part No. 93-4262
Part No. 93-4264
Part No. 94-6392
Part No. 94-6393
Part No. 98-2181
Part No. 98-2182
Advertisement
Table of Contents
