Table of Contents
Advertisement
5.2 Basic parameters
5.2.1
LG (Changing the language)
Command
LG
Either German or English can be selected for the help texts.
CAUTION: After changing the language settings, the ID button in the menu bar (WPC-300) must be
pressed (module identification).
5.2.2
MODE (Parameter view)
Command
MODE
This command changes the operating mode. Various commands (defined via STD/EXP) are blanked out in
Standard Mode. The commands in Expert Mode have a more significant influence on system behavior and
should accordingly be changed with care.
5.2.3 SENS (Malfunction monitor)
Command
SENS
This command is used to activate/deactivate the monitoring functions (4... 20 mA sensors, output current, sig-
nal range and internal failures) of the module.
ON:
All monitoring functions are active. Detected failures can be reset by deactivating the ENABLE in-
put.
OFF:
No monitoring function is active.
Auto reset mode. All monitoring functions are active. If the failure doesn't exist anymore, the mod-
AUTO:
ule automatically resumes to work.
Normally the monitoring functions are always active because otherwise no errors are detectable via
the READY output. Deactivating is possible mainly for troubleshooting.
Page 19 of 34
Parameters
x
x= DE|EN
Parameters
x
x= STD|EXP
Parameters
x
x= ON|OFF|AUTO
SCU-138-P-2230
Unit
-
Unit
-
Unit
-
Group
STD
Group
STD
Group
STD
05.06.2020
Advertisement
Table of Contents
