Table of Contents
Advertisement
5.2 Basic parameters
LG (Changing the language)
Command
LG
Either German or English can be selected for the help texts.
CAUTION: After changing the language settings the ID button (SPEED BUTTON) in the menu bar
(WPC-300) must be pressed (module identification).
MODE (Switching between parameter groups)
Command
MODE
This command changes the operating mode. Various commands (defined via STD/EXP) are blanked out in
Standard Mode. The commands in Expert Mode have a more significant influence on system behavior and
should accordingly be changed with care.
SENS (monitoring of the modul functions)
Command
SENS
This command is used to activate/deactivate the monitoring functions (4... 20 mA inputs and internal failures) of
the module.
ON:
All monitoring functions are active. Detected failures can be reset by deactivating the ENABLE input.
OFF:
No monitoring function is active.
AUTO:
Auto reset mode. All monitoring functions are active. If the failure does not exist anymore, the mod-
ule automatically resumes to work.
Normally the monitoring functions are always active because otherwise no errors are detectable via
the READY output. Deactivating is possible mainly for troubleshooting.
Page 20 of 32
W.E.ST.
Parameters
x
x= DE|EN
Parameters
x
x= STD|EXP
Parameters
x
x= ON|OFF|AUTO
PID-131-U-2030
Elektronik GmbH
Unit
-
Unit
-
Unit
-
Group
STD
Group
STD
Group
STD
30.12.2015
Advertisement
Table of Contents
