iOptron HAZ31 Instruction Manual page 14

Step 2A. Attach mount with a Leveling MiniPier
If an optional Leveling MiniPier #8042 is used, please follow these procedures. Currently, only
iOptron Carbon Fiber Tripod Version A will work with the MiniPier.
(1) Check the stainless steel adapting screw and make sure it is tightened to the base.
(2) Attach three leveling screws onto the tripod top;
(3) Attach MiniPier onto the tripod with three leveling screws. Loosely tighten both tripod center bolt
and tripod tray locking knob;
Figure 9. Bubble level
Adapting screw
Figure 10. Adapting screw on bottom of the MiniPier
Figure 11. Attach leveling screws
14
3X Recessed holes
for leveling screws