Table of Contents
Advertisement
Getting Started
Indicators on the optional Network Interface Board
1
1.
Indicator (green)
Is on when the power on the machine and
on while the machine is in a network en-
vironment.
- Status page
-
-
-
The status page of Network Interface Board will be automatically printed in the
following cases:
• when the printer is turned on.
• when Network Interface Board is reset.
This feature can be disabled with NIB Setup Tool which is included in the Smart-
NetMonitor for Admin program folder.
To disable this feature, check [Property Sheet] in the "NIB Setup Tool" screen.
Click [Detailed...] in the [General] tab and remove the check from the box for "Print
configuration page on start up".
Connecting the Machine to the Host Using the Parallel Interface
Cable
Connect the machine to the host computer using a parallel interface cable com-
pliant with IEEE 1284 (supplied by you).
Follow these steps to connect the machine to the host computer.
A
Confirm that you have the correct cable.
B
Confirm that both the machine and the host computer are turned off.
10
2.
Indicator (orange)
Is blinking while the machine is receiving
print jobs over the network environment
and off when the print jobs have been
sent to the controller.
Draft 2001/01/24
Advertisement
Table of Contents
