Aficio AP1015 Operating Instructions Manual page 18

Getting Started
Network cable requirements
Optional Network Interface Board Type 1018 can be installed to allow direct
connection to network.
1
The optional Network Interface Board supports 10BASE-T or 100BASE-TX con-
nections.
You can use the machine in the following network environments:
• Using the appropriate network management software and printer driver.
• Attaching the machine to a network (computer) set up as a server.
Client
Driver
File Server
Protocol
Under Windows NT 4.0, only × 86 CPU is supported.
*1
In a mixed network environment, the protocol switches automatically.
Reference
For more information about resolving network connection problems, see P.13
"Configuring the Printer for the Network".
Note
Consult your network administrator before connecting the machine to a net-
work.
Be sure to use properly shielded and grounded cable (STP, Category/Type5)
for the connection to the host computer (and/or HUB) in order to meet FCC
and EMC Directive 89/336/EEC emission guidelines.
Parallel cable requirements
Connect the machine to the host computer using a parallel port. This machine
does not provide the parallel cable to connect the machine to the host computer.
The machine's parallel interface is a standard bidirectional interface. It requires
a standard 36-pin parallel cable compliant with IEEE 1284 and a parallel port
available on the host computer.
Note
Do not use a parallel cable that is longer than 3 meters (10 feet).
8
Windows 95, 98, Me, Windows 2000, Windows NT 4.0,
or 9 (optional PS2 Kit Type 1018 is required)
PCL 6/5e, PS2
NetWare 3.x, NetWare 4.x, NetWare 5.x
TCP/IP, IPX/SPX, AppleTalk
*1
, Mac OS 8
Draft 2001/01/24