Connecting The Network Interface Cable To The Network - Aficio AP1015 Operating Instructions Manual

Connecting the Network Interface Cable to the Network

Connect the machine to the network using optional Network Interface Board
Type 1018.
Follow these steps to connect the machine.
A
Confirm that you have the correct cable.
B
Confirm that the machine is turned off.
C
Loop the network cable. The loop should be about 15cm (6") from the end
of the cable on the end closest to the printer.
D
Attach the ferrite core to the loop.
E
Attach the network cable to the 10BASE-T/100BASE-TX port on the ma-
chine.
Reference
See P.7 "Connecting the Machine" to confirm the position of the 10BASE-T/
100BASE-TX port.
Note
Confirm that the cable is connected to the 10BASE-T/100BASE-TX port.
F
Connect the other end of the cable into the network.
Connecting the Machine
Draft 2001/01/24
1
9