Download Print this page

Newco GXDF-8D Installation And Operation Manual page 6

Gxd series brewers

Advertisement

COFFEE PREPERATION PROCEDURES
1) Place filter into brew basket.
2) Put the appropriate amount of ground coffee into the filter for the volume of coffee being brewed.
3) Slide the brew basket into holder.
4) Set the volume selection switch to the appropriate position for the volume of coffee being brewed.
5) For warmer units:
Place empty decanter on warmer located directly under the brew basket.
Turn corresponding warmer switch to ON position.
For dispenser units:
Remove the dispenser lid unless it is a brew through design.
Place the dispenser directly under the brew basket.
6) Press brew start/stop switch. Note: a brew cycle may be initiated even if the heating light is on.
7) If the autoarm feature is enabled the heating light will begin to flash indicating that the brewer is heating and will
begin to brew immediately after the heating cycle is complete. Do not remove decanter. Brew cycle may be canceled
by depressing the brew start/stop switch. The heating light should no longer be flashing.
8) Hot water will be delivered through the sprayhead. This distributes the hot water evenly over the coffee bed within
the brew basket. The coffee brew will drain from the brew basket into the decanter below.
9) The status brewing light should continue to flash until all the liquid has finished flowing from the brew basket. Do not
remove decanter until the brewing process has stopped and all liquid has stopped flowing from the brewbasket.
10) The resultant coffee brew should be crystal clear and have the desired properties attainable through excellent
extraction.
11) To clean brew basket simply remove from brew rails and dump filter into wastebasket. The brewing process, as
described above, can now be started again.
GXD SERIES REPLACEMENT PARTS LIST
110307
PDS Valve Assembly, High Flow
100251
Valve, Solenoid, Hemco
152114
Dump Valve, Solenoid
102770
Faucet Assembly
701985
Tube Assembly, Sprayhead
701483
Sprayhead Assembly
100025
Gasket, Sprayhead
701870
Tank Assembly, 5500W/240V, 1 Phase
701875
Tank Assembly, 10500W/240V, 3 Phase
701286
Tank Element, 5500W/240V
701760
Tank Element, Five Loop, 3500W/240V
701690
Tank Element, Triple Loop, 3500W/240V
701619
Tank Element, 6000W/208V
701695
Tank Element, 6600W/240V
701305
Thermostat, Manual Reset
108143
Control Board (A)
108225
Control Board (B)
100008
Warmer Plate, Black Porcelainized
202053
Element, Warmer, 120W/120V (Mod -15)
110959
Element, Warmer, 150W/120V (Mod -30)
102841
Micro Switch, Faucet
201985
Switch, Start, Black
700434
Switch, SPST Black (I, II Volume Select)
100085
Switch, Lighted SPST, Red Rocker
701449
Light, Visa, Red
100236
Light, Heating
701714
Brew Basket, Plastic
701713
Brew Basket, S/S
701527
Brew Basket, Gourmet, S/S
6

Advertisement

loading

This manual is also suitable for:

Gxdf2-15Gxdf2-30