Steps
1. Remove the two screws (M2x3) that secure the USB/HDMI port bracket in place.
2. Remove the USB/HDMI port bracket away from the tablet.
3. Disconnect the USB/HDMI port cable from the connector on the system board and move it away from the system board.
4. Disconnect the coin-cell battery cable.
5. Unroute the coin-cell battery cable from the routing guides along the left side of the system board.
6. Peel the coin-cell battery off the system board.
Installing the coin-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the coin-cell battery and provides a visual representation of the installation procedure.
60
Removing and installing components