Blank Top-Cover; Removing The Blank Top-Cover - Dell Latitude 7230 Service Manual

About this task
The figure indicates the location of the RJ45-port assembly and provides a visual representation of the installation procedure.
Steps
NOTE: For models shipped with an expansion bay at the top side of the tablet.
1. Align the screw holes on the RJ45-port assembly with the screw holes on the tablet.
2. Replace the two screws (M2x3) to secure the RJ45-port assembly in place.
3. Align the screw holes on the RJ45-port cover with the screw holes on the RJ45-port assembly.
4. Replace the four screws (M2x5) to secure the RJ45-port cover to the RJ45-port assembly.
5. Connect the RJ45 FPC to the connector on the RJ45 daughter-board and close the latch.
Next steps
1. Install the back-cover
2. Install the batteries.
3. Install the handle (for models shipped with handle).
4. Install the stylus.
5. Follow the procedure in

Blank top-cover

Removing the blank top-cover

Prerequisites
1. Follow the procedure in
2. Remove the stylus.
3. Remove the handle (for the models shipped with a handle).
4. Remove the batteries.
5. Remove the back-cover
46 Removing and installing components
assembly.
after working inside your
before working inside your
assembly.
tablet.
tablet.