Dell Latitude 7230 Service Manual page 27

Steps
1. Place the tablet on a flat and clean surface.
2. Connect the power-button daughter board FPC to the connector on the system board.
3. Replace the single screw (M2x5) to secure the power-button daughter board FPC to the system board.
4. Carefully close the base-cover assembly to its 45° angle.
5. Connect the battery cable to the connector on the system board.
6. Place the base-cover assembly and press the edges of the base-cover assembly to secure in to the tablet.
7. Replace the two screws (M2x3) and 19 screws (M2.5x8—Torx 8) to secure the base-cover assembly in place.
Next steps
1. Install the handle (for the models shipped with a handle).
2. Install the stylus.
Removing and installing components 27