Troubleshooting - Oromed ORO-DENT PRO Manual

Nduction charger
1. Check the charger plug and cable at regular intervals, wipe the adapter plug
with a cloth.
2. Open the cover of charger base, then clean and dry charger at regular intervals.
Water tank cap
Wipe off any grime and dirt with a cloth.
Nozzle
1. Wash with water and wipe with soft cloth.
2. Replace the nozzle every 6 months.
Water suction tube
1. Wash with water and wipe with soft cloth.
2. Do not bend, pull or twist the water suction tube.
Tank
1. Wash with water and wipe with soft cloth.
2. Dry the tank when not using for a long period.

TROUBLESHOOTING

Problem
It does not work
It only works for a few mi-
nutes even after charging
Water pressure is very low
Water does not come out
Possible Cause
You've just purchased the
product or it has been left
unused for more than
3 months.
The battery has reached
the end of its lift cycle.
Charging time was insuf-
ficient.
There is dirt stuck in the
nozzle
The nozzle is deformed
There is dirt stuck in the filter
The tank is empty
The appliance is tilted too
much while in use
You've just purchased the
product or it has been left
unused for a period.
– 13 –
Solution
Charge the unit for about
24 hours.
Contact service center for
support.
Charge the unit for
about 24 hours.
Replace the nozzle
Clean the filter
Fill up tank
Use with the appliance in
a vertical state
Pull out the nozzle then
flush nozzle hole on the
body.