Connecting Multiple Devices - NETGEAR ME101 User Manual

Connecting Multiple Devices

ME101 Wireless
Ethernet Bridge
Default Ethernet DC in 5V Antenna
1. Turn off the gaming console(s) and other Ethernet-enabled device(s).
2. Connect the provided Ethernet cable between the ME101 Wireless Bridge and a hub.
3. Connect the powered down game console(s) and the powered down Ethernet-enabled
device(s) to the hub.
4. Connect the power adapter to the wireless bridge and plug the power adapter in to a
power outlet. The Power
5. Connect the power adapter to the hub. Plug the hub's power adapter in to a power outlet.
6. After the Wireless light
7. Turn on any other Ethernet-enabled devices.
If the bridge and the Ethernet-enabled device(s) are successfully connected, the Network
light on the bridge will light up. This light flashes when there is network activity.
Note: If your setup works with the default settings, you don't need to install the software
from the provided CD to configure the bridge unless you need to change the
Country/Region setting from the default setting (U.S.A.) or you have more than one
ME101 bridge on your network.
EN104
10 BASE-T HUB Link Rx
PWR
Normal / Uplink
COL
1 2 3 4
EN104TP Ethernet Hub
and Wireless LAN
on the bridge lights up, turn on any game console(s).
Cable or
DSL modem
PC
lights should light up.
Wireless Router
MR814
Gaming console or other
Ethernet-enabled device
6