Connecting Additional Wireless Client Devices After Wps Setup - NETGEAR WNR2000v2 User Manual

Connecting Additional Wireless Client Devices after WPS Setup

You can add WPS-enabled and non-WPS-enabled client devices.
Adding Additional WPS-Enabled Clients
To add an additional wireless client device that is WPS enabled:
Note: Your wireless settings do not change when you add an additional WPS-enabled
client unless you have cleared the Keep Existing Wireless Settings check box (in
the Wireless Settings screen). If you do clear the check box, a new SSID and a
passphrase are generated, and all existing connected wireless clients are
disassociated and disconnected from the router.
1. Follow the procedures in
on page 2-15.
2. For information about how to view a list of all devices connected to your router (including
wireless and Ethernet-connected), see
Adding Additional Non-WPS-Enabled Clients
If you are connecting a combination of WPS-enabled clients and clients that are not WPS enabled,
you cannot use the WPS setup procedures to add clients that are not WPS enabled.
To connect both non-WPS-enabled and WPS-enabled clients to the WNR2000v2 router:
1. Configure the settings of the WNR2000v2 router (shown in the Wireless Settings screen) for
WPA-PSK or WPA2-PSK security, and record that information. See
and WPA2-PSK Wireless Security" on page
When you change security settings, all existing connected wireless clients that do not share
those settings are disassociated and disconnected from the router.
2. For the non-WPS-enabled devices that you wish to connect, open the networking utility, and
follow the utility's instructions to enter security settings.
3. For the WPS-enabled devices that you wish to connect, follow the procedures in
'N' Connect (Wi-Fi Protected Setup)" on page
The WNR2000v2 router automatically preserves the settings you configured in
clients share the same security settings (for more information, see
Settings" on page
Safeguarding Your Network
NETGEAR Wireless-N 300 Router WNR2000v2 User Manual
"Push Button Configuration" on page 2-14
"Viewing a List of Attached Devices" on page
2-17).
v1.0, January 2010
2-10.
2-13.
"Configuring the WPS
or "Security PIN Entry"
6-7.
"Configuring WPA-PSK
"Using Push
step 1 so all
2-18