Connect A Pc To The Hub - NETGEAR FE116 Installation Manual

Connect a PC to the Hub

You can connect any device equipped with a 100BASE-T Ethernet interface to the RJ-45 ports on
the Model FE116 hub. These standard RJ-45 ports accept either 2-pair or 4-pair Category 5 UTP
cable (100BASE-TX networks require only 2-pair wiring). The RJ-45 interface is an 8-pin
connector.
To connect any of the RJ-45 ports on your Model FE116 hub to a PC, use a regular straight-
through UTP cable. If you are connecting using Port 16 on your hub, set the Normal/Uplink push
button to Normal.
Note: Ethernet specifications limit the cable length between your PC or server and the
hub to 328 feet (100 meters) in length.
Model FE116 Fast Ethernet Hub Installation Giude
8496FA