Table of Contents
Advertisement
■ Certification marks acquired by the printer are located inside
the film chamber�
■ Cautions During Printing
Do not shake the
Do not drop the
printer while
printer while
printing.
printing.
■ INSTAX WIDE Instant Film and Print Care
See FUJIFILM INSTAX WIDE instant film pack use instructions.
Follow all instructions for safe and proper use.
1. Keep the film in a cool place. Do not leave the film in a place
where the temperature is extremely high (e.g., in a closed car)
for many hours.
2. Do not puncture, tear, or cut INSTAX WIDE instant film. If film
becomes damaged, do not use.
3. When you load a film pack, use the film as soon as possible.
4. If the film has been kept in a place where the temperature is
extremely high or low, bring it to room temperature before
loading or starting to print photos.
5. Be sure to use the film before the expiration or "Use Before" date.
6. Avoid airport checked luggage inspection and other strong
X-ray illumination. The effect of fogging, etc. may appear on
unused film. Carrying your printer and film onto an aircraft in
your carry-on luggage is recommended. (Check with each
airport for more information.)
7. Avoid strong light, and keep the developed prints in a cool and
dry place.
8. Do not puncture or cut this film as it contains a small amount
of caustic paste (high alkaline). Never let children or animals
put the film into their mouth. Also pay attention so that the
paste does not come into contact with skin or clothes.
9. If the paste inside the film comes into contact with skin or
clothes, immediately wash off with plenty of water. If the paste
comes into contact with the eyes or mouth, immediately wash
the area with plenty of water and contact a doctor. Note that
the alkaline inside the film remains active for about 10 minutes
after the photo has been printed.
12
Do not cover the
film ejection slot
while printing.
■ Cautions on Handling the Film and Prints
See below for film activities to be avoided.
Bluetooth® Devices: Cautions
IMPORTANT: Read the following notices before using the
product's built-in Bluetooth transmitter�
■ Use only as part of a Bluetooth network�
FUJIFILM Corporation and its affiliates do not accept liability for
damages resulting from unauthorized use. Do not use in
applications requiring a high degree of reliability, for example in
medical devices or other systems that may directly or indirectly
impact human life. When using the device in computer and other
systems that demand a greater degree of reliability than Bluetooth
networks, be sure to take all necessary precautions to ensure
safety and prevent malfunction.
■ Use only in the country in which the device was purchased�
This device conforms to regulations governing Bluetooth devices
in the country in which it was purchased. Observe all location
regulations when using the device. FUJIFILM Corporation and its
affiliates do not accept liability for problems arising from use in
other jurisdictions.
■ Wireless data (images) may be intercepted by third parties�
The security of data transmitted over wireless networks is not
guaranteed.
Do not use the device in locations subject to magnetic fields, static
electricity, or radio interference.
■ Do not use the transmitter in the vicinity of microwave ovens
or in other locations subject to magnetic fields, static
electricity, or radio interference that may prevent reception of
wireless signals� Mutual interference may occur when the
transmitter is used in the vicinity of other wireless devices
operating in the 2�4 GHz band�
■ The Bluetooth transmitter operates in the 2�4 GHz band� The
standard output is approximately 3�16 mW�
■ This device operates on the same frequency as commercial,
educational, and medical devices and wireless transmitters�
It also operates on the same frequency as licensed transmitters
and special unlicensed low-voltage transmitters used in radio-
frequency identification tracking systems for assembly lines and in
other similar applications.
Advertisement
Table of Contents
