Coleman Propane 5038 Instructions For Use Manual page 4

To Set Up
NOTE: Use 16.4 oz disposable propane cylinders
only. Do not connect to bulk propane systems. The
LP-gas cylinder(s) used with catalytic heaters must be
constructed and marked in accordance with the
specifications for LP-gas cylinders of the U.S.
Department of Transportation or Transport Canada,
CAN/CSA B339 .
The unit is completely assembled. Features
identified are Burner, Heater Valve, Support Legs,
and Ignition Button (Electronic Ignition only).
Propane tank is not included.
Burner
Support Ignition
Leg Button
CAUTION
• SERVICE SAFETY
• Keep all connections and fittings clean. Inspect propane
cylinder and heater propane connections for damage
before attaching.
• During set up, check all connections and fittings for leaks
using soapy water. Bubbles indicate a leak. Never use a flame.
4
Turn HEATER VALVE
to OFF.
Attach CYLINDER to
HEATER outdoors.
Heater
Valve
Rotate both Support
Legs into operating
position.
Support
Leg
Position HEATER as
shown on flat surface.
To Light
DANGER
• EXPLOSION - FIRE HAZARD
• Propane is heavier than air and can accumulate in low
places. If you smell gas, leave the area immediately.
• Always attach or detach propane source outdoors;
never while heater is lighted, near flame, pilot lights,
other ignition sources or while heater is hot to touch.
• This heater is red hot during use and can ignite
flammables too close to the burner. Keep flammables at
least 24 inches from the sides and 24 inches from the
top of the heater. Keep gasoline and other flammable
liquids and vapors well away from heater.
WARNING
• BURN HAZARD
•
Never leave heater unattended when hot or in use.
•
Keep out of reach of children.