Advertisement
state.
Copper port has not established an
OFF
active network connection.
No data or abnormal data is being
OFF
TX
transmitted through serial port.
Blinking
Serial port is transmitting data.
Serial port is not receiving data or
OFF
RX
receiving data abnormally
Blinking
Serial port is receiving data.
【Logging in to WEB Interface】
This device supports WEB management and configuration.
Computer can access the device via Ethernet interface. The
way of logging in to device's configuration interface via IE
browser is shown as below:
Step 1
Configure the IP addresses of computer and the
device to the same network segment, and the
network between them can be mutually accessed
Step 2
Enter device's IP address in the address bar of the
computer browser.
Step 3
Enter device's username and password in the login
window as shown below.
Step 4
Click "OK" button to login to the WEB interface of
the device.
Note:
The default IP address of the device is "192.168.1.254".
The default user name and password of the device is
"admin".
If the user name or password is lost, user can restore it
to factory settings via restore button or management
software; all modified configurations will be cleared
after restoring to factory settings, so please backup
configuration file in advance.
Please refer to user manual for specific configuration
method of logging in to WEB interface and other
configurations about network management function.
【Specification】
Panel
100M Copper Port
10/100Base-T(X)
RJ45 port
Serial Port
RS-232/485/422 3IN1 serial port,
DB9 interface
Indicator
Power indicator, network Link/Act
indicator, serial port transmission
and
receiving
running indicator
Power Supply
Input power supply
12～48VDC
Access terminal block
3-pin
5.08mm
blocks
Power Consumption
No-load
0.9W@12VDC
Full-load
1.1W@12VDC
Working Environment
Working temperature
-40~75℃
Storage temperature
-40~85℃
Working humidity
5%～95%(no condensation)
Protection grade
self-adapting
data
indicator,
pitch
terminal
IP40 (metal shell)
Advertisement
