Installation; Select A Location - NETGEAR ProSafe GSM7212 Hardware Installation Manual

Managed Layer 2 Switches GSM7212, GSM7224, and GSM7248 Hardware Installation Guide
4. Make sure that all items are present. See "Package Contents" on page 3-1.
5. Inspect the products and accessories for damage. Report any damage
immediately.

Installation

Install the equipment in the sequence presented in this chapter:

1. Select a Location.

See "Select a Location" on page 3-3.
2. Install the Switch.
See "Install the Switch" on page 3-5.
3. Check the installation.
See "Check the Installation" on page 3-6
4. Apply power, and check the LEDs.
See "Connect to Power and Check the LEDs" on page 3-6.
Select a Location
The switch can be mounted in a standard 19-inch (48.26-centimeter) rack, wall-
mounted, or left freestanding (placed on a tabletop).
The site where you install the switch can affect its performance. Before installing
the switch or switches, make sure that the location meets the following site
requirements.
Table 3-1. Site Requirements for Switch Location
Requirements
Mounting
Hardware Installation
Note: If any item is found missing or damaged, contact your local
NETGEAR reseller for replacement.
• Desktop installations: Provide a flat table or shelf surface.
• Rack-mount Iistallations: Use a 19-inch (48.3-centimeter) EIA
standard equipment rack that is grounded and physically
secure. You need the rack-mount kit supplied with your switch.
v1.0, March 2006
3-3