Working Instructions - NETGEAR ProSafe FSM7328S Configuration Manual

Layer 3 managed switch - firmware 6.0.0.15

Hide thumbs Also See for ProSafe FSM7328S:

WORKING INSTRUCTIONS

Set the Management IP address

1) Plugged the console cable to the Serial port of the switch and the serial port on the

2) Open a new Hyper Terminal session (connecting via the COM port) – settings 9600,

8 , None , 1, None

3) Power Cycle the switch

4) Upon POST the User: prompt will appear

5) Username is admin , password "blank"

6) Type Enable to access the privileged mode (password "blank" )

7) Type network protocol none to reset the network settings

8) Type network parms <<Management IP>> <<Subnet Mask>> <<Default Gateway

IP>>. For example network parms 192.168.0.1 255.255.255.0 192.168.0.1

9) User copy system:running-config nvram:startup-config to save the configuration

10) Check with show network if the settings are correct

The switch should now be accessible patching a CAT5 Straight-through cable. The PC

NIC must be configured with an IP address within the same subnet used to configure the

management IP of the switch (Example: 192.168.0.2 255.255.255.0

Creating a Routing VLAN2 and Routing VLAN3 via the SmartWizard

1) Access the GUI

2) Browse to Smart Wizard – VLAN routing Wizard

3) Assign the VLAN ID

4) Select the port(s) members of the VLAN (Use CTRL to select multiple ports)

5) Assign the VLAN IP address and Subnet Mask

6) Click on Submit. The UNIT/SLOT/PORT entry will show the Virtual PORT created

and associated to the new VLAN.

7) Perform point 1-6 to create VLAN3 (with relevant IP address)