NETGEAR ProSafe FSM7328S Configuration Manual page 6

Checking routing is in place on the switch
1) Browse to Routing – RIP – Interface Summary
2) The following situation should appear
NOTE: The RIP admin mode will show ENABLE only if at least one active device is
patched into a port in the relevant VLAN
NOTA BENE:
Router/Firewall:
If the firewall as in this case is patched into a port in a specific VLAN (VLAN2 here),
ensure its static routing table contains a route back to the VLAN IP address for each of
the other VLANS on the switch that require Internet access.
For example in this case the FVS Firewall must contain the following route:
192.10.11.0 (Subnet) 255.255.255.0 (Subnet Mask) 192.10.10.254 (Default Gateway).
On the other hand another option would be to run RIP on the Firewall.