Energizer EZPPB20V2B User Manual page 12

6) Frequently monitor the charger and battery pack while connected.
7) Unplug the charger and disconnect it from the battery pack when finished.
8) Allow the battery pack to cool completely before using it.
9) Store the charger and battery pack indoors, out of reach of children.
NOTE: If the battery does not fit properly, disconnect it and confirm that the battery pack
is the correct model for this charger as shown on the specification chart. Do not
charge any other battery pack or any battery pack that does not securely fit the charger.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down to room
temperature before charging. This will extend the life of your batteries.
NOTE: Remove battery pack from charger stand using your thumb or fingers, press the
battery's release button in and pull the battery pack off at the same time.
Battery capacity indicator
There are battery capacity indicators on the battery pack; you can check the capacity status of the battery if
you press the button. Before using the machine, please press switch trigger to check if the battery is full
enough to properly work.
The 3 LED lights will show the capacity level of the battery.
Inserting and removing the battery
1. Remove the battery: press the battery release latch in and at the same time pull the battery pack off.
2. To insert the battery, push the battery pack onto the contacts of the tool.
WARNING! Before making any adjustments ensure this tool is switched off with the direction
of rotation selector in the center position
5.2 INSTALL THE HANDLE
1) Screw the handle into the device.
2) You can screw the handle on the left or right of the device depending on the application.
12
.