Classic Accessories Deluxe PolyPro III Instructions

Instructions: Deluxe PolyPro III Car Cover
Caution
• Never cover a wet vehicle
• Not liable for repainted
surfaces or lacquer paint
• Do not cover the tail pipe
or exhaust
• A hot exhaust and muffler
can burn you and melt your
cover
• Be sure the hood and
engine are cool before you
put on your cover
• Never cover a convertible
with the top down
• Do not spread cover across
an open sunroof or t-roof
This cover is designed to be
water resistant and repellent
but it will not prevent water
from reaching the surface of
your vehicle.
Installation
Remove or retract your
antenna. If you have a fixed
antenna see below.
Your storage bag is attached
with a leash to the back of your
cover. Insert the storage bag
in your trunk near the center
latch and close the trunk. This
will help protect the cover from
theft and anchor the cover for
easier fitting.
Pull your cover over the roof
from the back to the front.
Drop your cover over the sides,
then fit the elastic hem of your
cover under the front bumper of
your vehicle. Secure your cover
under the rear bumper and
corners.
To secure your cover on your
vehicle, attach one end of the
supplied rope to a web loop set
in the side of your cover. Toss
the rope under the vehicle and
tie the rope to the web loop
on the opposite side. For extra
security you may also use a
cable lock in these web loops
(cable lock not supplied).
Antennas
Check your antenna—many
antennas simply unscrew at
their base. If your antenna
cannot be removed or
retracted, you will need to
make a small hole in your cover
for it.
Put your cover on as much of
your vehicle as you can without
covering the antenna. Mark the
area where your cover will go
over the antenna. With a sharp
pencil or pen, carefully push a
small hole in your cover. Peel
the backing from your antenna
patch and, centering the hole
in the patch over the hole in
your cover, adhere the patch
to your cover. Press the patch
down firmly. Carefully lift your
cover down over your antenna,
threading your antenna through
the hole, and finish fitting your
cover.
Care
Clean your cover with a soft
brush and lukewarm water or
machine wash in COLD water.
DO NOT USE SOAP as it may
remove the protective coating
added by the factory. Line dry
only; do not machine dry.
Avoid trapping moisture
under your cover. If your
vehicle is outside for long
periods or under snow, trapped
moisture can sometimes cause
paint to become cloudy. We
recommend removing your
cover every 30 days. Let your
vehicle dry completely before
reinstalling your cover.
Driver's Side Door
A handy zippered access door
on the driver's side allows you
to enter your vehicle without
removing the cover.
Storage
A handy storage bag is
provided for your cover. Be
sure the cover is completely
dry before you store it in the
storage bag for an extended
period.
Three Year Warranty
This product is factory
warranted for workmanship
and materials for three years
after purchase. Trailering or
use during transportation of
your vehicle will invalidate this
warranty.
71152 71162 71172 07cC59_003