Classic Accessories PolyX 300 Instructions

Instructions: PolyX 300 5th Wheel RV Cover

Warning:

Installation must be done with two
people. Never install on a windy
day or when the roof is slippery or
wet. Please take care when you are
on a ladder or the roof.
Caution:
Cover or tape any sharp
edges on your RV that could wear
against your RV cover. Be sure to
lower any roof antennas.

Tools:

Some radio antennas may
need to be unscrewed; usually with a
Phillips head screwdriver. Your cover
will fit over flexible or flat antennas
and AC units.

Installation

Note: Your cover has been packed so
that when unrolled on the roof it is
in the proper position for installation.
Fig. 1
the roof and take your cover out of
its storage bag Fig. 2).
Place the rolled-up cover at the front
center of the roof and unroll down
the center of the RV toward the
back (Fig. 3).
3 . Starting at the front, unfold your
cover from the center outwards.
Continue unfolding the cover as you
work toward the back, letting it fall
over the sides of your RV (Fig. 4).
Fig. 4
BE SURE THAT YOUR HELPER DOES
NOT PULL THE COVER WHILE YOU
ARE ON THE TOP OF IT. Make sure
the corners of the cover are at the
corners of your RV. Finish by zipping
all the panels closed on your cover
then pull the elasticized corners down
1. With
over the bumper of your RV.
another
4. Connect and loosely tighten
person use
the tension panel strap across the
the haul strap
bottom front of the nose of your 5th
attached to
wheel (Fig. 5) Then connect the rip-
the storage
and-grip straps that fold in on either
bag to lift the
side just under the nose of your 5th
cover to the
wheel (Fig. 6). Adjust and tighten
roof (Fig. 1)
straps as necessary for a snug fit.
2. Carefully
climb up on
Fig. 2
Fig. 3
5. Included with your cover is a toss
bag to help you attach the straps
under your RV. Clip the toss bag
to the buckle strap attached to the
tension panel (Fig 7). Now toss the
bag under your RV to the buckle on
the opposite side (Fig 8). Unclip the
strap from the bag and buckle the
bag to the next strap. Repeat with
the remaining straps.
6 . Adjust the strap length on the
tension panels across the front
Fig. 5
and back to fit your RV. Don't over
tighten—the straps should be snug,
not drum tight.
The sides of your cover can be
unzipped for access to the doors.
The panels can be rolled up and held
in place with the rip-and-grip straps
toward the top of each panel.
Your cover is equipped with extra
Fig. 6
long zipper pulls. To secure the zipper
pulls so that they do not drag on the
ground bring the ends of the zipper
pulls up and tuck them into the rip-
and-grip closure located at the base
of the zipper along the hem (Fig. 9).
Fig. 7
Fig. 8
Fig. 9