Classic Accessories Fairway Golf Car Wind-Block Kit Instructions

Instructions: Fairway Golf Car Wind-Block Kit

Parts

A
B
C

Installation

1. Attach a side-block [B] to both ends of the
under-windshield block [A]. Attach by matching
the rip-and-grip tabs on the side-blocks [B] to
the rip-and-grip tabs on the ends of the under-
windshield block [A]. The smooth end of each
side-block [B] should face out and the split
side should face in.
outside
B
face
2. Fit the under-windshield block [A] under
your windshield with the side-blocks [B]
up along the sides (Fig. 1). The position of
the side-blocks [B] on the block [A] may be
adjusted by repositioning the rip-and-grip tabs
that attach them.
3. Locate the two plastic flanges on the over-
windshield block [C]. Fit these flanges over the
top of the windshield where the windshield
bends over toward the front of your golf car.
Then flip the over-windshield block [C] up so it
fits under your golf car roof (Fig. 2).

Cleaning

Clean with a soft brush and water. Line dry.
1 under-windshield wind block
1 pair of wing blocks that attach to [A]
1 over-windshield block
inside
face
Fig. 1
B
A
Fig. 2
C
40-009-042001-00 09cG51_10706