Advertisement
2-5.
TERMINAL BOARD ASSY (TB1)
Note 1: When installing screws (3.5 × 20),
follow the installing procedure in
the numerical order given.
tightening torque :
.2 0.05
m
4
2
1 four screws
(3.5
20)
ire se i
– Top side view –
WO bord wire
(black)
terminal board
assy "–" terminal
terminal
terminal
(red)
(black)
Note 6: Check direction of terminals.
(terminal (black) is left side.
terminal (red) is right side.)
Note 7: Check that the caulking part of a terminal
has faced upward.
Note 8: Be careful not to attach a crack to a speaker
cabinet using the terminal of a wire.
Note 9: Check whether the terminal is inserted
conversely.
Note 10: Insert the terminal straightly.
Note 11: After terminal insertion, should check
acting as lock of the terminal completely.
caulking
part
1
3 terminal
(black)
4 terminal
packing
3
terminal (black)
5 terminal board assy (TB1)
terminal (red)
s a ed posi io o er i a pa
Note 2: Please check direction of the upper and lower sides of terminal packing.
Note 3: Check that terminal packing has not run aground with a terminal part.
WO bord wire
Note 4: Push the whole terminal packing with a finger. Check the terminal packing
(red)
Note 5: Check that terminal packing is not showing from screw holes of the terminal
terminal board
assy "+" terminal
terminal packing
caulking
part
3 terminal (red)
2 Pull out the terminal
board assy (TB1).
(Narrow side is the upper. Wide side is the bottom.)
not having shifted, not having floated or not being stuck.
board assy (TB1).
terminal (red)
SS-NA8ES
– Rear side view –
i
upper side
Narrow side
Wide side
terminal (black)
7
Advertisement
