Table of Contents
Advertisement
Network Settings
The network settings are used to set the gateway's communication ports, IP configurations, DNS and
DHCP server etc.
• Current WAN IP Address: The IP address of the WAN port.
• Listen Port UDP: It is not necessary to change the protocol of the communication port used by the
gateway, unless it conflicts with ports used by another device in your network.
• RTP Starting Port UDP: The initial value of the port number for transmitting voice data among
gateway(s). Each line requires 2 ports. For 400 series gateway 8 UDP ports are required. It is not
necessary to change these, unless it conflicts with ports used by another device in your network.
For example, if the starting port is 9000, then Line 1 is using ports 9000 and 9001, and Line 2 is using
ports 9002 and 9003, and so forth.
IP Configuration (Setting WAN Port)
There are three methods of obtaining a WAN IP address:
1. Static IP
2. DHCP, means a Dynamic IP (Cable Modem)
3. PPPoE (Dialup ADSL)
Using the DHCP and PPPoE for obtaining an IP address may vary. If you are not familiar with the network
connection, please contact your local ISP.
V400 Series VoIP Gateway User Guide
YML832 Rev1
23
Advertisement
Table of Contents
