Advertisement
6. Attach the 3/8" street elbow to the bottom of the
bottom of the tee connector. Make sure to apply
pipe sealant before attaching. Tighten with
wrench (Fig. 25).
7. Reinsert the grommet in the side of the
cart (Fig. 22).
8. Attach one end of the supplied hose to the
flared fitting on the side of the tee
connector (Fig. 26 and 27).
9. Assemble the 3/8" pipe nipple to the NG
regulator. Assemble the 3/8" FNPT to flared
fitting to the regulator. Use pipe sealant and
wrench tighten (Fig. 28).
10. Assemble the NG regulator with fittings to the
3/8" street elbow. The regulator should point
toward the rear of the grill. Use pipe sealant
and wrench tighten (Fig. 29).
Note: Pay attention to arrow on the NG
regulator indicating direction of gas flow.
The arrow should point toward the grill.
Remember to apply pipe sealant!
This completes the NG regulator installation.
8
Natural Gas Conversion Instructions
Fig 25
Fig 26
Fig 27
Fig 28
Fig 29
Advertisement
