Advertisement
10. Disconnect the right side flexline from the mani-
fold using the adjustable wrench. This will free
up the right side of the manifold (Fig. 9).
11. Disconnect the left side flexline from the back
infrared valve using an adjustable wrench. This
will free up the left side of the manifold (Fig. 10).
12. Remove the control knobs from the front of the
grill (Fig. 11).
13. Remove the two screws holding each bezel in
place on the control panel (Fig. 12).
14. Remove the bezels from the front control panel.
Note: The small bezel stays in place (Fig. 13).
15. Remove manifold from grill body (Fig. 14).
You are now ready to install
the new NG manifold.
Manifold
Natural Gas Conversion Instructions
Fig 14
Flex Line
Gas Inlet Flex Line
Manifold
Screws
Fig 9
Fig 10
Fig 11
Fig 12
Fig 13
5
Advertisement
