permaban AlphaJoint Installation Manual

www.rcrflooringproducts.com
RCR Flooring Products Limited
Mill Close, Lee Mill Industrial Estate, Ivybridge, Devon, PL21 9GL
t: +44 1752 895288
f: +44 1752 395800
e: info@rcrflooringproducts.com
Permaban AlphaJoint Installation Guide
Using Pin & Weld Method
Installation Guide Issue V1.0
14/07/22
01 Placing the AlphaJoint
Place joints on the floor with sleeves pointing up.
02 Place pins
Pins are situated towards the end of the stud, then tack welded in place. The tack weld will break
under the pressure of the concrete, this will allow the joint to open along the length of the stud with
the pin still in place.
Note: 4 pins per joint.
Pin
Plastic sheet
Pin
Sleeve
Pin
Pin
Edge of Stud
Pin
All content found within this installation guide is approximate. RCR Flooring Products Ltd reserves the right to amend this
installation guide at any time. For further details, please contact RCR Flooring Products Ltd.
Note; Tack weld
to end of stud.
RCR Flooring Products Ltd is registered in England & Wales - No. 02815314.