NAVMAN
1.5 Changing the battery
Always shut down the X300 before changing the battery.
Note: All system settings, and the calculated data that was stored
at the last controlled shutdown*, are retained when the battery is
removed. This information persists indefinitely until updated or reset.
1. Turn D-ring anti-clockwise and slide enclosure cover down to
open battery enclosure.
2. Insert battery with «» end as indicated inside enclosure.
3. Replace enclosure cover (ensuring lugs at the bottom of the
cover are aligned with slots in the enclosure surround), turn
D-ring clockwise to seal.
!
For best performance:
General use =
Below 5
If battery power becomes low during operation the battery icon
is displayed.
battery icon
constant = low power
flashing = approx. 5 min before automatic shutdown**
* Press and hold
** When battery power becomes too low to continue operation,
a controlled shutdown is automatically executed (current data
is saved).
X300 - General information
Alkaline
C =
NiMH
o
PM
to perform a controlled shutdown.
X300
1-7