Step 3: Connect Your Oscilloscope - pico Technology PicoScope 2000 Series User Manual

User's Guide

Step 3: Connect your oscilloscope

1. Connect the oscilloscope to your PC using the USB cable supplied, as shown in the connection
diagram below.
h
a
b
c
d
2. Wait for your computer to install the oscilloscope. While doing so it will display a message or
icon in the task bar telling you it has found the device.
3. Run the PicoScope software.
4. If you wish to use a probe, connect one to Channel A. Touching the metal tip of the probe
should cause a small 50 or 60 hertz signal to appear in the PicoScope window.
Once you have finished the basic installation, the PicoScope 6 User's Guide will provide further
information about setting up and using your oscilloscope.
DO231-11 Copyright © 2006–2022 Pico Technology Ltd. All rights reserved.
g
f
b
PicoScope PC Oscilloscope
Analog input channels
Digital input channels
AWG output BNC
PicoScope 2000 Series Oscilloscopes and MSOs
a
c
b
d
d
e
Oscilloscope USB port
f
Pico USB cable
g
PC USB port
h PC
d
b
e
b
d
7