Table of Contents
Advertisement
Installation Instructions
Simple installation in four easy steps:
• Determine pool/spa capacity (total gallons) and prepare the pool water
• Install the cell
• Install the power supply and controller
• Start and set the system
Prepare the Pool Water
1
Figure the pool/spa capacity, total gallons being circulated by the primary pump, using the
guidelines specified below.
Rectangular Pools: Length x Width x Average Depth x 7.48
Round Pools: Radius x Radius x 3.14 x Average Depth x 7.48
Oval Pools: Maximum Length x Minimum Width x Average Depth x 5.7
Irregular Shaped Pools: Divide the overall shape into smaller forms and figure the
capacity in each. Then add all areas together to obtain total gallons.
Superchlorinate (shock) the pool to eliminate any chlorine demand. Then test and balance
the pool to the following specifications. For specific chemical requirements, refer to the Reference
section of this document. For vinyl or fiberglass pools, refer to manufacturer's guidelines.
Free Chlorine
pH
Total Alkalinity
Calcium Hardness
Cyanuric Acid (Stabilizer)
Metals, Phosphates and Nitrate
1.0 - 3.0 parts per million (ppm)
7.4 - 7.6 ppm
80 - 120 ppm
200 - 400 ppm (Do not install system if
hardness is over 1200 ppm.)
Per local requirements
0 ppm
www.polarispool.com
Advertisement
Table of Contents
