Toro Groundsmaster 1200 Series Installation Instructions Manual page 5

Fender kit pull behind rotary mower

Hide thumbs Also See for Groundsmaster 1200 Series:

Installing the Fenders onto

the Machine

Parts needed for this procedure:

Capscrew (5/16 x 4 inches)

Washer (5/16 inch)

Flange locknut (5/16 inch)

Procedure

Align the holes in the support tube for the left

fender to the holes in the axle frame tube as

shown in

Figure

Note:

Ensure that the decal is aligned rearward

of the fender-support tube.

1. Decal

2. Axle frame tube

3. Flange locknut (5/16 inch)

Assemble the fender-support tube to the axle

frame tube

(Figure

4 inches). 2 washers (5/16 inch), and 2 flange

locknuts (5/16 inch).

Figure 5

4. Capscrew (5/16 x 4

inches)

5. Washer (5/16 inch)

6. Support tube

5) with 2 capscrews (5/16 x

Torque the nuts and bolts to 1978 to 2542 N∙m

(175 to 225 in-lb).

Repeat steps

other side of the machine.

g282353

through

for the fender at the

139-3174