Installation - Toro Groundsmaster 1200 Series Installation Instructions Manual

Installation

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1
Preparing the Machine
No Parts Required
Procedure
1. Connect the machine to the tow vehicle; refer to
the Operator's Manual for the machine.
2. Lower the mower decks; refer to the Operator's
Manual for your machine.
3. Engage the parking brake for the tow vehicle,
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operator's seat.
4. Chock the tires of the machine.
Description
No parts required
Fender
Support tube
Flange-head capscrew (5/16 x 1-3/4
inches)
Flange locknut (5/16 inch)
No parts required
Capscrew (5/16 x 4 inches)
Washer (5/16 inch)
Flange locknut (5/16 inch)
Qty.
–
Prepare the machine.
2
2
Assemble the fenders.
4
4
–
Drill the axle frame tube.
4
4 Install the fenders onto the machine.
4
5. Lower the jack and support the machine; refer to
the Operator's Manual for the machine.
Important:
You must fully support the
weight of the machine with the jack.
6. Disconnect the machine from the tow vehicle.
2
Assembling the Fenders
Parts needed for this procedure:
2 Fender
2 Support tube
4 Flange-head capscrew (5/16 x 1-3/4 inches)
4 Flange locknut (5/16 inch)
Procedure
1. Assemble the support tube to the bracket of the
fender with 2 flange-head capscrews (5/16 x
1-3/4 inches) and 2 flange locknuts (5/16 inch)
as shown in Figure
2
Use
1.