Toro Groundsmaster 1200 Series Installation Instructions Manual page 3

Figure 1
1. Flange-head capscrew
(5/16 x 1-3/4 inches)
2. Bracket (fender)
2. Assemble the other support tube to the other
fender bracket with 2 flange-head capscrews
(5/16 x 1-3/4 inches) and 2 flange locknuts (5/16
inch).
3. Torque the nuts and bolts to 1978 to 2542 N∙m
(175 to 225 in-lb).
g282354
3. Support tube
4. Flange locknut (5/16 inch)
3
Drilling the Axle Frame
Tube
No Parts Required
Procedure
1. Holes (axle frame tube)
If your machine does not have holes in the axle frame
tube (Figure 2) for the fender kit, perform the following
steps:
1. Measure 51 mm (2 inches) from the end of the
axle frame tube, and mark the tube as shown
in Figure 3A.
3
Figure 2
g284106