Installing Hook - Makita TD003GZ Instruction Manual

Application mode
(Impact force grade
displayed on panel)
1 (Soft)
T mode *
: The lamp is on.
* When the tool rotates counterclockwise, the impact per minute is the same as in 4 (max) mode, 4,100 min
NOTE: When using T mode, the timing to stop the driving varies depending on the type of the screw and material
to be driven. Make a test driving before using this mode.
NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
button .
NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The impact force
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
Use only driver bit/socket bit that has inserting portion
shown in the figure. Do not use any other driver bit/
socket bit.
► Fig.9
For tool with shallow driver bit hole
A=12mm
B=9mm
For tool with deep driver bit hole
A=17mm
B=14mm
A=12mm
B=9mm
Procedure 1
For tool with one-touch type sleeve
To install the driver bit, insert the driver bit into the
sleeve as far as it will go.
► Fig.10: 1. Driver bit 2. Sleeve
Maximum blows
-1
1,400 min (/min) Tightening with less force to avoid
screw thread breakage.
– Driving self-drilling screws to a thin
(The tool stops rotating metal plate with good finish.
soon after impact starts.)
Use only these types of driver
bits. Follow the procedure
1. (Note) Bit-piece is not
necessary.
To install these types of driver
bits, follow the procedure 1.
To install these types of driver
bits, follow the procedure 2.
(Note) Bit-piece is necessary
for installing the bit.
Purpose
Procedure 2
In addition to Procedure 1, insert the bit-piece into the
sleeve with its pointed end facing in.
► Fig.11: 1. Driver bit 2. Bit-piece 3. Sleeve
To remove the driver bit, pull the sleeve in the direction
of the arrow and pull the driver bit out.
► Fig.12: 1. Driver bit 2. Sleeve
NOTE: If the driver bit is not inserted deep enough into
the sleeve, the sleeve will not return to its original posi-
tion and the driver bit will not be secured. In this case, try
re-inserting the bit according to the instructions above.
NOTE: When it is difficult to insert the driver bit, pull the
sleeve and insert it into the sleeve as far as it will go.
NOTE: After inserting the driver bit, make sure that it
is firmly secured. If it comes out, do not use it.

Installing hook

WARNING:
for their intended purposes only, e.g., hanging the
tool on a tool belt between jobs or work intervals.
WARNING:
hook as too much force or irregular overburden
may cause damages to the tool resulting in per-
sonal injury.
CAUTION:
When installing the hook, always
secure it with the screw firmly. If not, the hook
may come off from the tool and result in the personal
injury.
CAUTION:
Make sure to hang the tool
securely before releasing your hold. Insufficient
or unbalanced hooking may cause falling off and you
may be injured.
10 ENGLISH
Example of application
Tightening sash screws or small
screws such as M6.
Tightening self-drilling screws.
Use the hanging/mounting parts
Be careful not to overload the
-1
(/min).
or